CaltechAUTHORS
  A Caltech Library Service

Plastic Work to Heat Conversion During High-Strain Rate Deformation of Mg and Mg Alloy

Ghosh, Dipankar and Kingstedt, Owen T. and Ravichandran, Guruswami (2017) Plastic Work to Heat Conversion During High-Strain Rate Deformation of Mg and Mg Alloy. Metallurgical and Materials Transactions A, 48 (1). pp. 14-19. ISSN 1073-5623. https://resolver.caltech.edu/CaltechAUTHORS:20161109-080226099

[img] PDF - Supplemental Material
See Usage Policy.

198kB

Use this Persistent URL to link to this item: https://resolver.caltech.edu/CaltechAUTHORS:20161109-080226099

Abstract

Magnesium and magnesium alloy were investigated for plastic work to heat conversion (β). Thermomechanical response was measured employing the shear-compression specimen geometry, a split-Hopkinson pressure bar, and an infra-red detector. β of both materials measured to be less than the common assumption of 0.9; however, heat conversion was observed to be greater for magnesium alloy. Thus, results suggest that alloying and grain size refinement not only improved yield strength but also affected the thermomechanical response.


Item Type:Article
Related URLs:
URLURL TypeDescription
http://dx.doi.org/10.1007/s11661-016-3825-8DOIArticle
http://rdcu.be/pdVQPublisherFree ReadCube access
ORCID:
AuthorORCID
Ghosh, Dipankar0000-0002-4574-9600
Ravichandran, Guruswami0000-0002-2912-0001
Additional Information:© 2016 The Minerals, Metals & Materials Society and ASM International. Manuscript submitted August 25, 2016. First Online: 20 October 2016. This research was sponsored by the Army Research Laboratory and was accomplished under Cooperative Agreement Number W911NF-12-2-0022. The views and conclusions contained in this document are those of the authors and should not be interpreted as representing the official policies, either expressed or implied, of the Army Research Laboratory or the U.S. Government. The U.S. Government is authorized to reproduce and distribute reprints for Government purposes notwithstanding any copyright notation herein. The authors acknowledge Dr. Laszlo Kecskes and N. M. Krywopusk (US Army Research Laboratory) for the Mg and AZ31B samples and microstructural data. D.G. also acknowledges Mr. Thibaud Talon (graduate student, Division of Engineering and Applied Science, California Institute of Technology, Pasadena, CA) for his help during the high-rate thermomechanical measurements.
Group:GALCIT
Funders:
Funding AgencyGrant Number
Army Research LaboratoryW911NF-12-2-0022
Issue or Number:1
Record Number:CaltechAUTHORS:20161109-080226099
Persistent URL:https://resolver.caltech.edu/CaltechAUTHORS:20161109-080226099
Official Citation:Ghosh, D., Kingstedt, O.T. & Ravichandran, G. Metall and Mat Trans A (2017) 48: 14. doi:10.1007/s11661-016-3825-8
Usage Policy:No commercial reproduction, distribution, display or performance rights in this work are provided.
ID Code:71861
Collection:CaltechAUTHORS
Deposited By: Tony Diaz
Deposited On:09 Nov 2016 17:28
Last Modified:24 Nov 2020 18:05

Repository Staff Only: item control page